Page 1 of 1

Forgets settings on Shut down and bootup

PostPosted: Mon Sep 24, 2012 1:20 pm
by bretsharon
X1 ® Professional Client Version 6.7.4 (Build 4054eu) Since I moved to this new machine, Windows 7, 64 bit, X1 does not remember my settings after I shut-down and then boot up. This does not happen when I merely emerge from hibernation???

Re: Forgets settings on Shut down and bootup

PostPosted: Tue Sep 25, 2012 1:43 am
by Kenward
What settings does X1 forget?

I am also using Windows 7, 64 bit. I suspect that Windows is closing before X1 has had a chance to save its settings.

As an experiment, you could set up X1 as you want, then close it. Start it again. Are your settings as required?

The shut it down again and restart Windows.

Is X1 still setup as you require?

The other problem could be read/write access to the folders that hold your customisation settings.

Re: Forgets settings on Shut down and bootup

PostPosted: Tue Sep 25, 2012 5:05 pm
by Chris Wheaton
Bretsharon - there is one "secret" to keeping your X1 customizations. Open X1. Configure as you desire then close the X1 interface - File > Exit. This should allow proper updating of any affected INI file and/or Registry values.

About a minute later feel free to relaunch X1 or reboot your system and relaunch X1 - your settings should be locked in.

Re: Forgets settings on Shut down and bootup

PostPosted: Sat Nov 01, 2014 5:24 am
by alison
Hello to you,

Is het possible to use X1 Professional client in a terminal server environment.
We have a Microsoft 2008 std server with terminal server licenses and want to use X1 professional client.
And if so do we need to install it for all the users?
Thanks in advance